Page 1 of 1

6.2 .NET DEPLOY

PostPosted: Fri Nov 01, 2013 3:36 am
by NITOX74
Hi,

we are trying to run an application that pops a simple form up without any coding.
It is compiled with TD 6.2 .NET and we are trying to run it under windows xp.
We have installed the VC++ 2008 redistributable package and the dotnetfx35setup.exe for the .Net framework from the DEPLOY folder
Everything works fine when executing a simple application build with TD 6.2 within the deploy folder.
The problem arises when trying to execute the .Net application.

The returned error "Application has generated an exception that could not be handled"
I guess we miss something about the installed frameworks or a specific configuration on them?
The question is
Should we add something in the deploy folder?

Thank you in advance!

Panayiotis

Re: 6.2 .NET DEPLOY

PostPosted: Wed Feb 26, 2014 6:34 am
by NITOX74
Hi,

We reinstalled the DEPLOY setup from TD 6.2 .NET package with great success :) ( Application is runnning )

Now we get another problem on Windows 2000 SERVER SP4 installations. Application is not running :(
We managed to install the .Net Framework 3.5 SP1, but after running the .Net Application, the OS returns:

Application has generated an exception that could not be handled
Process ID=0x7f0 (2032), Thread ID=0xa24 (2596).
Click OK to terminate the application.
Click CANCEL to debug the application.

Is it possible to make it work?
The task manager says that the .Net Application allocated 10.108KB from the Physical Memory right at the moment when the above error message appeared.
The OS available Physical Memory is at 32700KB and approximately 109MB Non Paged Virtual Memory at that time.
Could it be that the OS doesn't allow the application to run because of low memory or just a matter of dll incombatibility with the OS kernel?