Page 1 of 1

Crystal Reports and TD 61

PostPosted: Fri Jul 19, 2013 11:28 am
by JeaTX
Hallo,
I use CrytalReport Active X Viewer with the following code, refering this article: http://www.iceteagroup.com/Portals/0/Ne ... 010101.pdf

Local variables
Boolean: b
Ok
Variant: vBuff
CRAXDRT_Application: oApp
CRAXDRT_IReport: oRepObject
Variant: vDatasource

oApplication.OpenReport( "test.rpt", vBuff, oRepObject )
Call vDatasource.SetObject(oRepObject)
Call Combonent1.Datasource = vDatasource
Call Component1.ViewReport


This works fine, but my report uses parameters. How can I to this with the code above?

Best regards,